Radiative heat transfer in MHD mixed convection flow of nanofluids along a vertical channel
Over the past few decades, nanofluids have emerged as a promising technology for the enhancement of the intrinsic thermophysical properties of many convectional heat transfer fluids such as water and oil. Many researchers have been investigated the merits of dispersing nanometer-sized particles into...
Saved in:
| Main Author: | |
|---|---|
| Format: | Thesis |
| Language: | English |
| Published: |
2016
|
| Subjects: | |
| Online Access: | http://eprints.utm.my/id/eprint/80780/1/AaizaGulMFS2016_valet-20190217-110548.pdf http://eprints.utm.my/id/eprint/80780/ http://dms.library.utm.my:8080/vital/access/manager/Repository/vital:120545 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | Over the past few decades, nanofluids have emerged as a promising technology for the enhancement of the intrinsic thermophysical properties of many convectional heat transfer fluids such as water and oil. Many researchers have been investigated the merits of dispersing nanometer-sized particles into base fluids to enhance heat transfer, thermal conductivity and viscosity of the fluids. Therefore, this research focused on radiative heat transfer in magnethohydrodynamics mixed convection flow in a channel filled with nanofluids containing different type of nanoparticles. Five types of nanoparticles (Al2O3, 3 4Fe O , Cu, 2 TiO , and Ag) with five different shapes (platelet, blade, cylinder, brick and spherical) were used in water 2 (H O) and ethylene glycol 2 6 2 (C H O), as conventional base fluid. An important subtype of nanofluids called ferrofluids 3 4 (Fe O in water based nanofluids) was also studied. Four different problems were modelled as partial differential equations with physical boundary conditions. In the first three problems, the channel walls were taken rigid, while the fourth problem the walls were chosen permeable where suction or injection was taking place. Perturbed type analytical solutions for velocity and temperature were obtained and discussed graphically in various graphs. Results for skin friction and Nusselt number were also computed and presented in tabular forms. This study showed that 2 6 2 C H O was the better convectional base fluid compared to 2 H O because of the higher viscosity and thermal conductivity. Ag nanoparticles had the highest thermal conductivity and viscosity compared to other type of nanoparticles. Increasing nanoparticles size had caused variation in velocity. It was also observed that, variation in velocity for Ag nanoparticles was obtained at low volume concentration, whereas for 2 3 Al O nanoparticles, this variation was observed only at high volume concentration. Velocity increases with increasing Grashof number, radiation, heat generation and permeability parameters, but decreases with increasing magnetic parameter and volume fraction of nanoparticles. However, the effects of these parameters were quite different in the case of suction and injection. Results had also shown that, temperature increases with increasing radiation and heat generation parameters. In this study, the temperature of ferrofluids was found smaller when compared to the temperature of nanofluids. |
|---|