表紙画像

The strain rate intensity factor in the plane strain compression of thin anisotropic metal strip

Using an available analytic solution for instantaneous plane strain compression of a plastically anisotropic strip between two parallel plates the strain rate intensity factor is found assuming Hill’s quadratic yield criterion. The distribution of material properties is uniform. The effect of parame...

保存先:

書誌詳細
主要な著者:	Alexandrov, Sergei E., Yusof, Mustafa
フォーマット:	論文
出版事項:	Kluwer Academic Publishers 2014
主題:	TJ Mechanical engineering and machinery
オンライン･アクセス:	http://eprints.utm.my/id/eprint/63024/ http://dx.doi.org/10.1007/s11012-014-0039-2
タグ:	タグ追加タグなし, このレコードへの初めてのタグを付けませんか!

類似資料

An accurate upper bound solution for plane strain extrusion through a wedge-shaped die
著者:: Alexandrov, Sergei, 等
出版事項: (2014)

Effect of plastic anisotropy on the limit load of highly under-matched joints: a conceptual approach to plane strain problems
著者:: Alexandrov, Sergei, 等
出版事項: (2013)

Effect of white layer on residual autofrettage stresses and strains in open - end cylinders
著者:: Alexandrov, Sergei, 等
出版事項: (2016)

Steady planar ideal flow of anisotropic materials
著者:: Alexandrov, S., 等
出版事項: (2016)

Experimental evaluation of RBD palm stearin as cold metal by plane strain extrusion test
著者:: Syahrullail, S., 等
出版事項: (2007)

Plane Strain Fracture Toughness Determination for Magnesium Alloy
著者:: Mohd Daud, Mohd Ahadlin
出版事項: (2012)

A New Divergence Method for Plane Strain Element
著者:: Cheikhna , Sidi Mohamed
出版事項: (2018)

Measurement and prediction of compressive properties of polymers at high strain rate loading
著者:: Mohd Firdaus, Omar, 等
出版事項: (2011)

Strain Rate Effects of Polymeric Foam Cores Under Compressive Loading
著者:: M. R. M., Rejab, 等
出版事項: (2008)

The performance of RBD palm stearin as cold metal working lubricant by plane strain extrusion test
著者:: S., Syahrullail, 等
出版事項: (2007)

Experimental evaluation of RBD palm olein as lubricant in cold metal forming by Plane strain extrusion
著者:: S., Syahrullail, 等
出版事項: (2007)

The effects of the die half angle of taper die on plane strain extrusion
著者:: Zuan, A. M. S., 等
出版事項: (2016)

Micro-pits effectiveness for controlling friction in plane strain extrusion
著者:: Shafie, Ahmad Shafarin
出版事項: (2011)

$Ductile fracture strain in uniaxial tensile test of plane specimen’s$

Ductile fracture strain in uniaxial tensile test of plane specimen’s
著者:: Mohamed Zulqarnain, Mohamed Akram
出版事項: (2012)

Neural Network Model and Finite Element Simulation of Spring back in Plane-Strain Metallic Beam Bending
著者:: Abu Khadra, Fayiz Y. M.
出版事項: (2006)

Compressive Properties of Carbon Fibre Reinforced Plastic (CFRP) at Low Strain Rate
著者:: Ahmad, Roslan, 等
出版事項: (2001)

Strain rates effect of dynamic compression properties of E-glass / jute composite
著者:: Mat Jusoh, Muhamad Shahirul, 等
出版事項: (2020)

Strain-rate-dependent stress-strain behavior of offshore clay
著者:: Jegan Nadarajan
出版事項: (2024)

Strain rate effect on the failure strain and hardness of metallic armour plates subjected to high velocity projectile impact
著者:: Shah, Qasim H.
出版事項: (2006)

2D modelling of a thin elasto-plastic interphase between two different materials: Plane strain case
著者:: Mishuris, Gennady, 等
出版事項: (2007)

The effect of lubricant viscosity in cold forward plane strain extrusion test
著者:: Samion, Syahrullail, 等
出版事項: (2009)

Investigation of micro-pits formation on billet surfaces in plane strain extrusion
著者:: Izhan, I. M., 等
出版事項: (2016)

$Determination of plane strain fracture toughness for AZ61 Magnesium alloy$

Determination of plane strain fracture toughness for AZ61 Magnesium alloy
著者:: M. A. M., Daud, 等
出版事項: (2010)

Kinetics of carburizing of duplex stainless steel (DSS) by superplastic compression at different strain rates
著者:: Ahamad, Nor Wahida, 等
出版事項: (2010)

Impact of sandwiched strain periodic multilayer AlN/GaN on strain and crystalline quality of a-plane GaN
著者:: Kamarundzaman, Anas, 等
出版事項: (2021)

Impact of sandwiched strain periodic multilayer AlN GaN on strain and crystalline quality of a-plane GaN
著者:: Omar Ayad Fadhil Al-Zuhairi
出版事項: (2021)

Quasi-static axially symmetric viscoplastic flows near very rough walls
著者:: Alexandrov, Sergei Evgenievich, 等
出版事項: (2015)

Prediction of maximum strain and strain rate in SHPB specimens based on energy analysis
著者:: Nurizzatul Atikha, Rahmat
出版事項: (2013)

Stress Intensity Factor for a Crack in a Strip
著者:: Hashim, Mohammad Hafiz
出版事項: (2010)

Impact of sandwiched strain periodic multilayer AlN/GaN on strain and crystalline quality of a-plane GaN (SCOPUS)
著者:: Anas Kamarundzaman
出版事項: (2021)

The effect of strain rate of steel material
著者:: Ahmad Firdaus, Mohd Sabri
出版事項: (2012)

Effect of strain rate on indentation behaviour of kenaf-based fibre metal laminates
著者:: Pang, Chi Loog, 等
出版事項: (2014)

Compressive strength and thermal conductivity of metakaolin geopolymers with anisotropic insulations
著者:: Yun-Ming, Liew, 等
出版事項: (2022)

Determination of stress intensity factor of actuated cracked aluminum plate using strain gages
著者:: Awang Bujang, Awang Hadi Ifwat, 等
出版事項: (2018)

Determination of stress intensity factor of actuated cracked aluminum plate using strain gages
著者:: Awang Bujang, Awang Hadi Ifwat, 等
出版事項: (2019)

Investigation of frictional constraint effect of RBD palm stearin as lubricant by plane strain extrusion
著者:: Syahrullail, Samion, 等
出版事項: (2009)

Stress intensity factor for multiple cracks in half plane elasticity
著者:: Elfakhakhre, Nawara R. F., 等
出版事項: (2016)

Author Correction: Impact of sandwiched strain periodic multilayer AlN/GaN on strain and crystalline quality of a-plane GaN (SCOPUS)
著者:: Anas Kamarundzaman
出版事項: (2021)

Measurement of coefficient of friction under bulk plastic deformation by using plane strain extrusion apparatus with plane plate tool and taper die
著者:: Kamitani, Shunpei, 等
出版事項: (2012)

Effect of strain rate on vane shear test
著者:: Ling, John Heng Teck.
出版事項: (2017)