صورة الغلاف

SINGLE STAGE RF AMPLIFIER AT 5.8GHZ ISM BAND WITH IEEE 802.11a STANDARD

This paper describes the circuit design and measurement of a single stage RF amplifier for 5.8 GHz-band with IEEE 802.11a standards for WLAN applications.The circuit was simulated using Ansoft Designer where a 14dB of gain; input and output return loss less than -10dB were observed. The GaAs Hetroju...

وصف كامل

محفوظ في:
التفاصيل البيبلوغرافية
المؤلفون الرئيسيون: Othman, A. R., Ibrahim, I. M., Samingan, M. S. A. S., Aziz, A. A. A., Selamat, M. F. M., Halim, H. C.
التنسيق: Conference or Workshop Item
اللغة:English
منشور في: 2007
الموضوعات:
Q Science (General)
الوصول للمادة أونلاين:http://eprints.utem.edu.my/id/eprint/6831/1/Single_stage_RF_amplifier_at_5.8GHz_ISM_band_with_IEEE_802.11a_standard.pdf
http://eprints.utem.edu.my/id/eprint/6831/
http://www.apace2007.org/
الوسوم: إضافة وسم
لا توجد وسوم, كن أول من يضع وسما على هذه التسجيلة!
الوصف
الملخص:This paper describes the circuit design and measurement of a single stage RF amplifier for 5.8 GHz-band with IEEE 802.11a standards for WLAN applications.The circuit was simulated using Ansoft Designer where a 14dB of gain; input and output return loss less than -10dB were observed. The GaAs Hetrojunction FET (HFET), capacitors and resistors are combined with the microstrip line pattern by silver epoxy. A 1dB output power compression point (P1dB) of 17dBm and 14.56dB of gain when -1dBm power injected under 6V and ½ Idss biasing are measured.

مواد مشابهة