Enhancing Mechanical Properties of Fiber-Reinforced Self-Compacting Geopolymer Concrete Using Lightweight Aggregate
The research aims to investigate SCGC performance as a suitable alternative to the traditional concrete. The research will study the effect of LWCA, steel fiber and curing condition on the fresh and hardened properties of SCGC. The main materials will be used for SCGC are fly ash and slag. Curing wi...
Saved in:
| Main Authors: | , , |
|---|---|
| Other Authors: | |
| Format: | Article |
| Published: |
International Information and Engineering Technology Association
2025
|
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | The research aims to investigate SCGC performance as a suitable alternative to the traditional concrete. The research will study the effect of LWCA, steel fiber and curing condition on the fresh and hardened properties of SCGC. The main materials will be used for SCGC are fly ash and slag. Curing will be performed using oven, and ambient temperature. Steel fibers SF will be incorporated into the mixture at 0%, 0.5%, 1% and 1.5% of binder content. While the natural coarse aggregate will be replaced by LWCA with 0%, 33.3%, 66.67% and 100% by weight. Analysis of this (SCGC) were done for both fresh and hardened state to assess the mechanical properties of (SCGC). This study finds that the addition of both LWCA and SF decreased the blend's L-Box ratio and slump flow value. All SCGC mixtures fulfilled the EFNARC guidelines and standards. Results reported that Mixes with a greater percentage of LWCA and SF became more cohesive and viscous. Results revealed that the SCGC exposed into ambient air curing condition had lower flexural strength, compressive strength, and tensile strength than of heating curing condition. The compressive strength CS of samples(M1-M9) exposed to heating conditions compared to the ambient ones increased about 36.09%, 26.32%, 17.88%, 23.87%, 27.96%, 27.69%, 38.94%, 27.91% and 24.53% respectively. The better CS values were 38.94% for M7 mix and 36.08% for M1 Mixtures. The FS of samples exposed to heating conditions compared to the ambient ones increased about 13.39%, 13.39%, 23.78%, 18.64%, 17.85%, 11.67%, 34.70%, 8.65% and 12.24% respectively the better flexural strength value was 34.70%, of M7 mix exposed to heating conditions. The better TS value was 26.22 Mpa for M3 Mixes at 1.5% of SF, While the TS reported dropping about 38.4% when applying LWCA as partially replacement of 66.67% with ambient curing condition. The study findings that the (CS) of mixes were proportional directly with steel fibers percentage till (1.0%). The CS, FS and TS of SCGC decreased when increasing LWCA. As a result, the SCGC that cured in oven showed enhancement in each fresh and mechanical properties, therefore, it is recommend to utilize the (SCGC) in hot areas and utilize wastes such as steel fibers and LWCA in SCGC as an economic, affordable and eco-friendly material. Copyright: ? 2024 The authors. |
|---|