表紙画像

Effect of Holding Time and Temperature to the Sintered Characteristic of Alloy Formed...

FYP 1 Sem 1 2019 / 2020

保存先:

書誌詳細
第一著者:	Mohd Shauqi Bin Ahmad Shukri
フォーマット:
出版事項:	2023
主題:	SINTERING OF ALLOY
タグ:	タグ追加タグなし, このレコードへの初めてのタグを付けませんか!

類似資料

Effect of Holding Time and Temperature to The Sintered Characteristic of Alloy Formed Through Warm Compaction Route
著者:: Mohd Shauqi Bin Ahmad Shauqi
出版事項: (2023)

Formation of FeCrAl alloy by compacting at elevated temperature and sintering at different schedule
著者:: Muhammad Qhaider Zulkafli
出版事項: (2024)

Formation of FeCrAl alloy by compacting at elevated temperature and sintering at different schedule
著者:: Muhammad Amir Afzam Awang
出版事項: (2024)

Synthesis and characterization of Fe-Al alloy with different sintering temperature
著者:: Maimun Razali
出版事項: (2008)

Effect of sintering rate and temperature to the final characteristics of alloy powder compact formed through warm compaction
著者:: Muhammad Aidishamil Mohd Tahir
出版事項: (2024)

Effects of sintering temperature on microstructure and complex permittivity of magnesium titanate-doped barium strontium titanate prepared via mechanical alloying
著者:: Abdul Halim, Dayang Nur Fazliana
出版事項: (2018)

Sintering atmosphere effect on Al-0.2Mg alloy
著者:: Muhammad Firdaus Rosli
出版事項: (2008)

The effect of sintering temperture to the microstructure of PM F75 (Co-Cr-Mo) alloy
著者:: Mohd Tajuddin Mohd Idris, 等
出版事項: (2009)

Study on different sintering temperature on the composite ferum and cobalt reinforced with silicon carbide
著者:: Durairaj Ehambron
出版事項: (2008)

Characterization of Co-Cr-Mo (F-75) alloy produced by solid state sintering
著者:: Zuraidawani, Che Daud, 等
出版事項: (2011)

The effects of sintering schedule on iron powder ASG100.29 formed at elevated temperature
著者:: Khaled Ehab Abdullah Mohamed
出版事項: (2024)

The effect of iron addition and tungsten content on the corrosion resistance of w-pre alloy brass composite
著者:: Rozi, Ewol
出版事項: (2017)

The influence of sintering temperature to the physical properties of P/M Co-Cr-Mo (F-75) alloy
著者:: Zuraidawani, Che Daud, 等
出版事項: (2010)

Sintering behavior and microstructural characterization of Aluminium copper powder compacts (Al- 4.4 Cu-0.8 Si-0.5 Mg Wt% ) alloy prepared by powder metallurgy
著者:: Looi Mei Yen
出版事項: (2008)

Effect of sintering parameter on the densification and mechanical properties of microwave sintered copper
著者:: Mohd Nasruddin, Mohamad Ghazali
出版事項: (2016)

The effect of different sintering temperature to the properties of cow bone hydroxyapatite
著者:: Shahrizal, Md Hussein
出版事項: (2014)

Sintering behavior and microstructure evolution of mechanically alloyed W–bronze composite powders by two-step ball milling process
著者:: Kahtan S., Muhammed, Dr., 等
出版事項: (2014)

Effect of alloying elements on carburizing response of sintered iron containing hosphorus
著者:: Mohammed Misbahul, Amin
出版事項: (2009)

Hybrid microwave sintering of Fe-Cr-SiC
著者:: Khairul Nisak, Kamis
出版事項: (2021)

Self-Fluxing Mechanism in Geopolymerization for Low-Sintering Temperature of Ceramic
著者:: Noorina Hidayu, Jamil, 等
出版事項: (2021)

Effect of sintering on the physical and mechanical properties of Co-Cr-Mo (F-75)/HAP composites
著者:: Nur Maizatul Shima, Adzali, Dr., 等
出版事項: (2014)

Fabrication and characterization of hybrid microwave assisted sintering Sn-0.7Cu + 1.0wt.% Si₃N₄ composite solder
著者:: Flora, Somidin
出版事項: (2019)

Microstructure of development Al-Mg-Si-Cu powder metallurgy under different addition of Sn
著者:: Khairunnisa Omar
出版事項: (2008)

Influence of Sintering Temperature on Crystallization Behavior of Cordierite synthesized from Non-Stoichiometric Formulation
著者:: K. K., Eing, 等
出版事項: (2020)

Effects of ramp rates with short holding time on the sinterability of hydroxyapatite
著者:: Samuel L.K.L., 等
出版事項: (2023)

Hybrid microwave sintering of Fe-Cr-Cu
著者:: Siti Syafiqah, Sakor
出版事項: (2021)

The anodizing of sintered Mg/Ca alloys
著者:: Norhadira Fatin, Wardi
出版事項: (2017)

Effect of sintering parameters on the densification and mechanical properties of microwave sintered stainless steel powder
著者:: Lau, Yong Ang
出版事項: (2012)

The effect of alloying elements in sintered-recycle steel compaction
著者:: Mohd Fauzi Jaafar
出版事項: (2008)

The effect of sintering temperature on mechanical properties of natural and synthetic Hydroxyapatite with Alumina (1%) as an additive
著者:: Rozaima Yusoff
出版事項: (2008)

The effect of sintering temperature to the properties of zinc oxide
著者:: Lim, J. H., 等
出版事項: (2014)

Effects of sintering atmosphere and temperature on physical properties of mullite-based ceramic from black rice husk ash and alumina mixture
著者:: Mohamed, Nurzilla
出版事項: (2014)

The effect of sintering scedule on iron powder ( ASC 10029) mixed with aluminium powder formed at elevated temperature
著者:: Muhammad Alif Naiman Bin Nordin
出版事項: (2023)

The effect of cooling condition on the microstructure and properties of Al-4.4Cu-0.8Si-0.5Mg powder compacts
著者:: Khairul Nazri Taha
出版事項: (2008)

Effect of admixing CU and sintering parameters on the densification and mechanical properties of microwave sintered 316L stainless steel
著者:: Ching, Chin Ho
出版事項: (2014)

Characterization of Co-Cr-Mo (F-75) alloy produced by solid state sintering
著者:: Zuraidawani, Che Daud, 等
出版事項: (2010)

The effect of sintering on the properties of powder metallurgy (PM) F-75 alloy
著者:: Zuraidawani, Che Daud, 等
出版事項: (2014)

Physical properties of F75 (Co-Cr-Mo Alloys) mixed with Hydroxyapatite (HAP) for Biomedical devices
著者:: A.M. Rohaya, 等
出版事項: (2009)

Role of sintering temperature in production of nepheline ceramics-based geopolymer with addition of ultra-high molecular weight polyethylene
著者:: Romisuhani, Ahmad, 等
出版事項: (2022)

Optimization of sintering temperature on microwave sintering of the composite iron-chromium reinforced with alumina particles
著者:: Wan Abdul Rahman Assyahid, Wan Ibrahim, 等
出版事項: (2014)