Numerical simulation for high subsonic turbine blades by modified k-e turbulent models / Nurfazliawati Idris
This study presents the validation of two equation turbulence model (k-epsilon) that incorporates fixed variables of exit Reynolds number 2.8 x 106 and 0.79 as exit isentropic Mach number on a turbine blade simulation by ANSYS software. The boundary condition of this study has been set to be 140kPa...
保存先:
| 第一著者: | |
|---|---|
| フォーマット: | 学位論文 |
| 言語: | English |
| 出版事項: |
2019
|
| オンライン･アクセス: | https://ir.uitm.edu.my/id/eprint/89197/1/89197.pdf https://ir.uitm.edu.my/id/eprint/89197/ |
| タグ: |
タグ追加
タグなし, このレコードへの初めてのタグを付けませんか!
|
| 要約: | This study presents the validation of two equation turbulence model (k-epsilon) that incorporates fixed variables of exit Reynolds number 2.8 x 106 and 0.79 as exit isentropic Mach number on a turbine blade simulation by ANSYS software. The boundary condition of this study has been set to be 140kPa and 280K as the inlet pressure and inlet temperature of the model. The validation of dimensionless pressure distribution, isentropic Mach number and Fast Fourier Transformation (FFT) has been used as parameter study. The result of isentropic Mach number around the blade has recently indicates very good agreement with the experiment while the result of FFT captures the pressure fluctuation at trailing edge of the turbine blade with the 4.6% of discrepancy with experiment result. For the dimensionless pressure distribution, the result has some discrepancy. Then, a new hybrid turbulence model has been done and the improvement of the result has been achieved. The result of hybrid equation shows that isentropic Mach number and dimensionless pressure distribution validation became closer to the experimental result compared to the unmodified equation. Thus, the calculation that should be used to obtain a better result is by isentropic relation for total inlet pressure as it could be farther result to the experiment if directly uses a total pressure. |
|---|