Numerical analysis of Al2O3 Nanofluids in serpentine cooling plate of PEM fuel cell / Irnie Azlin Zakaria...[et al.]
PEM fuel cell converts the energy potential of a hydrogen based fuel into electricity with water and heat as the major by-products. In order to optimize the performance of a PEM fuel cell, the cooling system is responsible to manage the accompanying heat. In this study, heat transfer and fluid flow...
Saved in:
| Main Authors: | , , , , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Faculty of Mechanical Engineering Universiti Teknologi MARA (UiTM)
2018
|
| Subjects: | |
| Online Access: | http://ir.uitm.edu.my/id/eprint/36265/1/36265.pdf http://ir.uitm.edu.my/id/eprint/36265/ https://jmeche.uitm.edu.my/ |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | PEM fuel cell converts the energy potential of a hydrogen based fuel into electricity with water and heat as the major by-products. In order to optimize the performance of a PEM fuel cell, the cooling system is responsible to manage the accompanying heat. In this study, heat transfer and fluid flow performance of Aluminium oxide, Al2O3 nanofluids in a serpentine cooling plate is investigated numerically. The Al2O3 nanofluids concentration of 0.1%, 0.3% and 0.5% was dispersed in both water and 60:40 and 50:50 water:ethylene glycol (w:EG) mixture of base fluids. The thermo-physical properties of the prepared nanofluids namely thermal conductivity and viscosity were measured and then fed to the simulation to enable maximum accuracy to the real experimentation result. A steady and incompressible flow with constant heat flux is assumed in the carbon graphite channel of 210mm x 220mm. All characteristics studied is at Re number range of 150 to 400. A serpentine cooling plate is used to mimic a single cooling plate in a complete stack of PEM fuel cell. The simulation used was ANSYS Fluent in laminar flow condition. The result shows that the heat transfer coefficient of 0.5 % volume concentration of Al2O3 in 100:0(w:EG) has increased up to 37 % as compared to base fluid. The increase in pumping power is experienced but at a much lower value as compared to the thermal management advantage. |
|---|